#8 1-5/8" Cement Board Screw
Estimated Availability Date:
Call for Availability : 778-330-2602
The Grabber Flat Wafer Head Screw, Alternating Thread, 8 X 1-5/8".
Description
Grabber Cement Board and High-Density Sheathing Screws have been specifically designed for use with Cement board and High-density exterior sheathing. These exterior grade corrosion-resistant fasteners have a .40" (10.5mm) wafer head with nibs to facilitate seating and minimize strip-out. Grabber alternating thread screws are for use for the attachment of these boards to steel from 20 to 25 gauge.
Specifications
| Gauge | #8 | ||
| Length | 1-5/8-in | ||
| Head Type | Wafer with nibs | ||
| Recess Type | #2 Phillips | ||
| Thread Type | Single lead alternating (high-low) | ||
| Coating | GrabberGard |
Installation Guidelines
Use a standard screwgun with a depth-sensitive nose piece. Suggested screwgun specification for optimal performance: 4 amps minimum and RPM range of 0 to 2,500. Install with head flush with board, no need to counter sink. Overdriving might result in fastener failure or strip out of the work surface.
- Cement Board: Cement board is built with a combination of reinforcing fibers and cement assembled into standard sheet sizes at 1/4 to 1/2 inch thick. Cement board is typically used as a tile backing board.
| Vendor Part #: | GCB8158HL |
- Article | IP Ratings Learn more about what an IP rating is and how this rating system is used.
https://www.blackcrowfasteners.com/cs_wiki/wiki/47-i...
